Usage Of Carbide Saw Blade

Today, Jiangsu Hanma take you to understand the use of cemented carbide saw blade:

1. Please hang the carbide saw blade vertically on a dry shelf, avoid damp places, avoid using corrosive solvent when cleaning, clean the blade when it is not used for a long time, and then put it in the original carton for proper placement.

2. The hard alloy saw blade has sharp serrations, so it is forbidden to collide or fall to the ground. It must be handled lightly.

3. When installing the carbide saw blade, it is necessary to confirm the performance and use of the saw table first, and check whether the alloy saw blade is cracked, distorted, uneven, tooth loss and other phenomena before installation.

4. After installing the carbide saw blade, make sure that the center hole of the saw blade is firmly fixed on the saw table. The cutting direction indicated by the carbide saw blade arrow is aligned with the rotation direction of the saw table. It is forbidden to install in the opposite direction, because the wrong direction will lead to tooth loss.

5. After replacing the carbide saw blade, pre-turn for one minute before use, and then cut when the saw table enters the working state.

6. When cutting the material, the aluminum alloy saw blade in normal operation must be gently cut into the material, and hard pressing and pushing are prohibited.

7. It is forbidden to reverse the carbide saw blade, which will lead to tooth loss and danger.

8. If you hear abnormal sound, abnormal shaking and abnormal cutting surface during operation, please stop the operation immediately and find the abnormal cause. Replace carbide saw blade. It is forbidden to stop the saw blade suddenly in the middle of the object to be cut. Stopping in the middle of the cutting will cause the saw blade to fall off and become deformed.

9. Please wipe anti-rust oil after cutting to prevent the saw blade from rusting. When the sawtooth is not sharp, it is necessary to regrind the sawtooth. It must be grinded by the manufacturer to increase the service life of the carbide saw blade.