Common Problems And Solutions Of Circular Saw Blades

1 Common problems：High speed circular saw machine from time to time there is a large vibration

   Solution: first check whether the equipment is placed high or low or uneven, check whether the equipment bearing is bad, the machine shell should be kept    intact, the grinding wheel of the equipment is not eccentric and other problems, and finally check whether the gear is intact, bearing seat is worn; If there is still no    way to solve the problem, contact the manufacturer immediately.

2 Problem：circular saw blade suddenly stops working or equipment stops action:

  Solution: this happens mostly line problem, should be immediately cut off the power supply, check the line, the test voltage is stable, the power supply is normal, if   there is a link ground, near the presence of influential voltage apparatus and equipment, etc., there is a kind of situation, is the problem the device itself, see saw   blades have item gets stuck, or other parts shall also check; If there is a problem with the equipment itself, this needs to be checked by a professional.

3 Problem：the operator in the operation of the equipment is very loud

   Solution: Most of the possibilities are bearings, such as eccentric grinding wheel, damage, gear damage, etc., such hardware damage should contact suppliers for    maintenance or replacement.

4 Problem：metal circular saw machine equipment produces smoke phenomenon

   Solution: appear this kind of phenomenon is commonly the device is entering aging stage, it is inevitable, but if it is just to buy equipment, so probably not for a    long time for the maintenance, if the enterprise of equipment cleaning up don't care, don't transition according to the requirement to use, not a reasonable time    to rest; Another situation is that the equipment parts are aging, or the metal circular saw blade has reached its service life and needs to be replaced. When this    happens, the equipment should be stopped immediately, the fault should be carefully examined, and the problem can be turned on again before being solved.

5 Problem：machine tool equipment odor

   Solution: If the operator at work, found that the equipment has a peculiar smell, should immediately stop the equipment, cut off the power supply, can be because    of the line problem, do a system check on the equipment, or the equipment fatigue transition, high temperature phenomenon caused by the peculiar smell; If you    cannot find out the situation, you should ask a professional to come over for maintenance.

6 Problem：high-speed circular saw machine equipment on the protective shell wear phenomenon

   Solution: the company should carefully check the equipment when purchasing equipment integrity, if you want to use a kind of protection shell found there is any    breakage or wear and tear, possibility is a human negligence, such as: workers are not careful to equipment firm pressure, using a long time, when using high    temperature melting phenomenon, too long to wear out case, etc., can contact the manufacturer to replace.