How To Keep Carbide Saw Blade Milling Cutter Sharp

As a special tool for circular saw, carbide saw blade milling cutter is not only related to the cost of sawing, but also the basis of cutting workpiece quality. Therefore, carbide saw blade milling cutter attaches great importance to metal cutting processing enterprises. How should enterprises keep the blade sharp.

1、 Daily protection

Does alloy saw blade need protection? Yes, any of the same products need maintenance and protection. Although the product is a kind of cutting tool, it is also a kind of expendable product. If there is no reasonable protection, it will not only affect its sharp wear too fast, but also reduce the quality of the enterprise itself!

1. Corresponding type and equipment

Alloy saw blade has strict requirements, different types correspond to different equipment, can't match it at will, for example: cutting metal saw blade, used to cut wood, this is a very common fault, some layman think cutting metal can, cutting wood should be faster, more sharp! If the saw blade used in the metal circular saw machine is used to cut wood, the result will be tooth sticking and tooth collapse. The consumption of the saw blade is too large and the cost is too high.

2. Grasp the time of replacing saw blade

Cemented carbide saw blade is a consumer goods, has its use life, many enterprises think that when cutting processing, if the use period is not to, will not replace, directly can not stop! Indeed, this is what all enterprises are doing. They think it's normal and reasonable, but they don't know it's a very lazy way of doing it;

If the life of a saw blade is 40 square meters, it should be replaced when it is cut to 20 square meters. After the rest, at least 30 square meters can be cut. People will be more energetic after the rest, and the product is the same!

3. Related to its equipment

The quality of the metal circular saw equipment will also affect the quality of the saw blade. The harmony and compatibility between them are very important. If a good saw blade is put on the equipment with very poor quality, its effect will be at least reduced by more than half.

If the equipment can't cut the data beyond the scope, it will not only affect the performance and stability of the equipment, but also cause great damage to the cemented carbide saw blade. Similarly, the equipment should have its reasonable rest section, which can also drive the breathing time of the saw blade.

2、 Grasp the details

Details are very important, and often determine the result. Enterprises that do not pay attention to this aspect will not be too successful. At least the equipment used and the cost of sawing are much higher than those of their peers.

1. Before the end of the operation, it is necessary to carefully clean the saw blade without any residue on it, which is conducive to the persistence of its sharpness;

2. In the installation process, we must strictly abide by its technical guidance, not reverse installation, not reverse operation!

3. Before operation, it is necessary to check the corresponding equipment and data, and clean up the dirty sawing data in time;

4. In the process of operation, if it is found that it is very hot and cannot be sprayed directly with water, oil mist shall be used.

The above is the most basic protection method, in order to delay the sharp of carbide saw blade milling cutter, it is necessary to operate according to the application requirements.