Call Us: +86-511-86328209Email: dfrjchensir@163.com

Discussion On Daily Use Standard Of Carbide Saw Blade Milling Cutter

Apr 24, 2021

The hard alloy saw blade milling cutter should be operated strictly according to relevant regulations in daily use. If it is not used in standard, it will seriously affect the quality of equipment in sawing data, and also affect the service life of carbide saw blade milling cutter, which is a loss of profits for enterprises.

1、 Handling in detail

1. The cutter head of carbide saw blade is extremely sensitive and sharp, and it is also very easy to damage. During transportation or equipment, it is necessary to pay attention to it, and try not to touch hard materials to prevent damage and other situations.

2. During the application, it is required to regularly check the radial run out of the main shaft of the blocking equipment according to relevant regulations ± 0.02mm range, and equipment swing, can not be exceeded ± 0.01mm.

3. Before the device, the carbide saw blade milling cutter must adhere to the cleaning of the equipment and saw blade, timely remove the related sundries. The flange plate must be flat and clean, and the shaft should be straight intersected.

4. To make circular saw blade more stable, please use the flange plate with a large range and adhere to the common size of all flange. The specific diameter of the large and thin diameter shall be 1/2d of the diameter of 1/3 ultra thin carbide saw blade milling cutter, so that the cutting effect of the workpiece is better.

5. Whether or not the new or used circular saw blade is completed or started, it should be idled for about 20 seconds before the device is finished or started to ensure all normal operation.

6. When the carbide saw blade milling cutter is installed, pay attention to the tightening of flange plate, and it cannot be too loose, otherwise it will appear that there is a slip phenomenon in the blocking. If it is too tight, the circular saw will be damaged or blocked and deformed.

7. Please wear necessary protective equipment according to relevant regulations during operation.

2、 On the grinding in use

1. If the quality of the cut-off workpiece is found to be obviously unqualified or the distance is large, it should consider whether the saw blade needs to be repaired.

2. When the data loss is too large or the carbide saw blade milling cutter is found to be loud.

3. The edge wear is less than 0.2mm.

4. The edge of the blocked workpiece is irregular or the burr is too large.

It is important to insist on the timely grinding of carbide saw blade milling cutter. If the grinding is not enough, it will seriously affect the effect after the second grinding, even make the service life. It is very important to form permanent damage, which leads to the failure of secondary grinding. When it reaches the time of grinding, if it is still used continuously, every 10% cutting amount will be increased, It will cause 50% alloy damage.