Analysis Of Common Causes Of Metal Circular Saw Blade Wearing Too Fast

The rapid wear of metal circular saw blade will lead to the improvement of cutting cost, including the reduction of workpiece quality, which is very bad for the efficiency of enterprises. How to avoid the rapid wear of metal circular saw blade, it is necessary to understand the causes of the situation first.

Many times, we need to learn to reverse thinking, for example, if we want to make the metal circular saw blade wear too fast, what should we do? Trust that many enterprises will understand that it is relatively efficient to deal with problems in this way.

1、 Feed speed

Each metal circular saw blade corresponds to different sizes of materials (including different types of materials), and has its corresponding feed speed, from slow to fast. If it exceeds this range, it will seriously affect the service life of the saw blade, especially the simple damage to the serrated parts.

At the moment when the metal circular saw blade touches the material, its effect force is very large (contact friction). The faster the cutting speed is, the stronger the force is; If the speed exceeds the specified speed, there will be tooth breakage, tooth cracking and other situations. In severe cases, the whole saw blade will collapse and burst.

Therefore, no matter how busy the enterprise is in production or during operation, it is not allowed to adjust the feed speed of the equipment without authorization, and it is necessary to operate in strict accordance with the relevant regulations.

2、 Magnetic powder clutch

The magnetic powder clutch has a protective effect on the metal circular saw blade. If it stops working due to abnormal conditions or other faults, it will seriously threaten the application of the saw blade.

In daily work, the maintenance and inspection of the equipment should be carried out every day, which helps to reduce the damage to the metal circular saw blade caused by equipment problems, and also extends the service life of the equipment; In many cases, the occurrence of the problem is the neglect of some details, such as the screw is not tightened, the parameters are not set correctly and so on.

3、 Materials

In the process of cutting off the incoming materials, one work is often ignored by enterprises, that is to check the incoming materials. Sometimes the surface of some materials is very unsmooth, especially some severe concave convex phenomenon, which is one of the most common factors leading to the shortening of the service life of metal circular saw blades.

It is necessary to check the sawing materials before purchasing or cutting, so as to sweep out the severe and irregular materials, first carry out certain processing operation, and then enter the equipment to cut, so as to ensure the normal use of metal circular saw blade, and also help to extend the service life and improve the sawing quality.

The above are the common reasons for the rapid wear of metal circular saw blade. Reasonable and standardized use is helpful to improve the work efficiency of enterprises.